TRUmill X440 Experience from Pro-Craft Dental


Well id like to start off by stating that this is the third mill we’ve had installed at our laboratory, And by far the easiest. Set up was about 3 hours, and after a quick run through we were machining in no time. On the surface the x440 interface is very straight forward and simple . Though there is an administrator mode appears more in depth, as it should. Also the support from 3DBioCAD has been second to none to say the least. Charles and Sun were awesome. By the very next morning, before Sun and Charles showed up, we were already machining by ourselves. But It is due to the fact of the user friendly software and support. Hyperdent (CAM software) is by far the nicest I’ve worked with. Quick Calculations, and super expedited connector placement. All in all we are very satisfied with our purchase of the TRUmill x440 .

Chuy, Procraft Dental Laboratory